Filter
Top Products
11
GETTING STARTED
3. Set the TONE/PULSE switch located on the right side
of the base to correct dialing mode. Please check with
your local telephone company if uncertain of the type
of service.
4. Lift the handset and listen for a dial tone. The phone is
ready to use.
Wall Mounting Instructions
The phone unit may be mounted on a standard wall plate.
The mounting bracket will mount on the telephone with
the larger tabs towards the bottom of the phone.
1. Pull the handset hook out of the base and reverse its
position so that the hook points up and will hold the
handset when you hang up. See Figure 4.
2. Plug one end of the short fl at telephone line cord into
the jack marked LINE located on the back of the
telephone. Then run the cord through the groove on
the back of the phone.
3. Insert the tabs of the mounting bracket into the slots
in the back of the phone. Push the mounting bracket in
and down fi rmly until it snaps into place. See Figure 5.
MANUAL
AUTO
Figure 5
Figure 4