Filter
Top Products
Basic Call Handling
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.0 23
Tips
• To start a secure conference, you must use a phone configured with security.
• Non-secure conferences and participants display a icon.
• Calls must be on the same line before you can add them to a conference using Confrn or Join. (Join
is available on SCCP phones only.)
• Depending on how your phone is configured, if you leave a conference after initiating it, the
conference might end. To avoid this, transfer the conference before hanging up.
See who started the
conference
While viewing the conference list, locate the person listed at the
bottom of the list with an asterisk (*) next to the name.
Drop the last party added to
the conference
Press RMLstC.
You can remove participants only if you initiated the conference call.
Remove any conference
participant
1. Highlight the participant’s name.
2. Press Remove.
You can remove participants only if you initiated the conference.
End your participation in a
conference
Hang up or press EndCall.
Join together two standard
conferences on the same line
On SCCP phones, use the Join or DirTrfr softkeys.
On SIP phones, use the Confrn or Transfer softkeys.
Check with your system administrator to see if this feature is
available to you.
Verify that a conference call is
secure
Look for the or icon after “Conference” on the phone
screen.
Remove a non-secure
participant from a conference
While viewing the Conference List, locate the participant without the
or icon, and press Remove.
Check with your system administrator to see if non-initiators of a
conference can remove participants.
If you want to... Then...