Filter
Top Products
2
Program Accessories
Gate Access Panel (GAPLM)
Step 1: On the phone connected to the OTIUEX,
press “**07” after hearing the dial tone. Listen for a
double beep. Hang up and Learn LED will flash for
15 seconds. If an error tone is heard it means that
memory will have to be cleared (see
Troubleshooting).
Step 2: Within 15 seconds enter Master PIN Number
on GAPLM.
Step 3: Press “05” and GAPLM will beep. The
OTIUEX will ring the telephone and Caller ID will
display “Unit Learned”.
DAILM
Step 1: Set Dipswitch #1 on the DAILM to the UP
position to set the DAILM as a primary device.
Step 2: On the phone connected to the OTIUEX,
press “**07” after hearing the dial tone. Listen for a
double beep. Hang up and Learn LED will flash for
15 seconds. If an error tone is heard it means that
memory will have to be cleared (see
Troubleshooting).
Step 3: Within 15 seconds, press and release the
Learn button on the DAILM.
Step 4: The OTIUEX will ring the telephone and
Caller ID will display “Unit Learned”.
Repeaters
Step 1: On the phone connected to the OTIUEX,
press “**07” after hearing the dial tone. Listen for a
double beep. Hang up and Learn LED will flash for
15 seconds. If an error tone is heard it means that
memory will have to be cleared (see
Troubleshooting).
Step 2: Within 15 seconds press the Learn button on
ONE Repeater. LED will light.
Step 3: The OTIUEX will ring the telephone and
Caller ID will display “Unit Learned”.
NOTE: If the Repeaters have not been programmed
to anything within an existing network, see Repeater
manual for further instructions.
NOTE: If programming into an existing network,
ensure that the OTIUEX is programmed to the Active
unit.