Filter
Top Products
3
Step 1: Press and release the Learn button on the
intercom.
Step 2: Within 20 seconds enter Master PIN Number
on MUGAPLM.
Step 3: Press “05”.
Step 4: Followed by (00-63)
Step 5: Then press the Call Button. Intercom will
beep indicating programming is successful.
When the Call button is pressed on the MUGAPLM,
the intercom will beep for 40 seconds. During this
time, the intercom will ONLY connect to the
MUGAPLM. Hold down the Talk button on the
intercom to speak to the visitor. Release the Talk
button to hear the response. This will be a secure
conversation and other intercoms will be locked out.
The intercom can also display Gate Status and be put
into Conference Mode by changing the Switch
Settings.
For complete installation and operating instructions
refer to Portable Intercom manual.
Portable Intercom
Pre-Installed LiftMaster
Receiver (315Mhz Only)
Step 1: Pry open the front
panel of the receiver case
with a coin or a screwdriver.
Step 2: Press and release
the Learn button on the
receiver. The Indicator Light
will light for 30 seconds
indicating that receiver is in Learn
Mode.
Step 3: Within 30 seconds enter Master PIN Number
on GAPLM.
Step 4: Press “1”. The Indicator Light on the receiver
will blink 3 times indicating programming is
successful.
NOTE: An error tone will be heard for 3 consecutive
activations only. After the third activation the
MUGAPLM assumes that the GCU has been
replaced with the receiver.
Repeat Steps 2-4 for each remote, or control device
that will be used to access the LiftMaster door or gate
operator.
Program
Indicator Light
Learn Button
Erase All Control Codes
Press and hold the Learn button on the receiver until
the Indicator Light turns off indicating that the receiver
memory is clear (about 6 seconds).
NOTE: The MUOTIU acts as a wireless remote
autodialer in a dedicated line system.
Step 1: On the phone connected to the MUOTIU,
press “**07” after hearing the dial tone. Hang up and
Learn LED will flash for 15 seconds. If an error tone is
heard it means that memory will have to be cleared
(Refer to MUOTIU manual).
Step 2: Within 15 seconds enter Master PIN Number
on MUGAPLM.
Step 3: Press “05” and MUGAPLM will beep.
Step 4: Followed by (00-63)
Step 5: Then press the Call Button. The MUOTIU will
ring the telephone and Caller ID will display “Unit
Learned”.
For complete installation and operating instructions
refer to MUOTIU manual.
Indoor Multi-Unit Telephone Interface
(MUOTIU)
Programming Accessories
NOTE: If using the OTIU, each residence that wants
to use this feature must each have a OTIU.
Step 1: On the phone connected to the OTIU, press
“**07” after hearing the dial tone. Hang up and Learn
LED will flash for 15 seconds. If an error tone is heard
it means that memory will have to be cleared (Refer
to OTIU manual).
Step 2: Within 15 seconds enter Master PIN Number
on MUGAPLM.
Step 3: Press “05” and MUGAPLM will beep.
Step 4: Followed by (00-63)
Step 5: Then press the Call Button. The OTIU will
ring the telephone and Caller ID will display “Unit
Learned”.
For complete installation and operating instructions
refer to OTIU manual.
Indoor Telephone Interface Unit (OTIU)
Programming Accessories