Filter
Top Products
Manual Connect Intercom can be initiated from either head-
set by pressing the MC button for scala rider Q2
pro
and
CTRL button for any earlier scala rider headset.
RESET INTERCOM PAIRING
You can delete all of the headset’s Intercom pairings at any time.
1. With the scala rider Q2
pro
headset turned ON, press and hold the
CTRL Button for at least six seconds until the Red and Blue Lights
begin rapidly alternating.
2. Press and hold the Volume Up Button for three seconds.
3. The Red and Blue Lights will ash ve times simultaneously
and then the headset will turn o, conrming that Reset was
successfully completed.
SET UP FOR MOBILE PHONE CALLS:
PAIRING
If you have a Bluetooth enabled mobile phone and would like to
make and receive phone calls using the scala rider Q2
pro
, you must
rst pair your headset to the mobile phone.
NOTE: If you have a compatible Bluetooth GPS device you wish
to use with the scala rider Q2
pro
, please skip this step, and
continue ahead to SET UP FOR BLUETOOTH GPS DEVICE.
Pairing is a one time process. Once the headset is paired to a
specific mobile phone during this Setup Procedure, they will
remain paired and automatically recognize each other whenever
they are within range. If the connection between the phone and
headset is lost, tap the CTRL button to reconnect the devices.
TO PAIR THE SCALA RIDER Q2
pro
TO A BLUETOOTH
MOBILE PHONE
1. Turn on your phone and make sure its Bluetooth function is
activated.
2. With the scala rider Q2
pro
headset turned ON, press and
hold the CTRL Button for at least six seconds until the Red and
Blue Lights begin ashing simultaneously.
3. Search for Bluetooth devices on your phone by following the
phone’s instructions. Please consult your phone’s User Manual
for more information.
4. After a few seconds the phone will list the “scala rider Q2
Pro”
as a discovered device. Select it and follow your phone’s
instructions to accept the pairing.
5. When prompted enter 0000 (four zeros) as your PIN or passkey.
6. Your phone will conrm that pairing has succeeded and the
headset will begin ashing slowly in Blue.
NOTE: If the Pairing process is not completed within two minutes the
headset will return to Standby mode.
With some mobile phones, you may need to tap the CTRL button
to connect the headset to the phone after pairing is complete. The
scala rider Q2
pro
headset will automatically connect to the last
phone connected to the headset.
SET UP FOR BLUETOOTH GPS DEVICE:
PAIRING
If you have a Bluetooth enabled GPS device and would like to transmit
navigation instructions and sounds from the GPS device through the
headset’s speakers, you must rst pair your headset to the GPS device.
NOTE: Not all Bluetooth enabled GPS devices allow connections to
Bluetooth headsets like the scala rider Q2
pro
. Please consult your
GPS device’s User Manual for more information.
TO PAIR THE SCALA RIDER Q2
pro
TO A BLUETOOTH
GPS DEVICE:
1. Turn on your GPS device.
6
scala rider
®
Q2
™
MultiSet pro