Filter
Top Products
8
BT Freestyle 4100 – Issue 2 – Edition 3 – 12.01.04 – 5853
2. Plug the telephone line cord into the base.
(ILLUSTRATION)
Do not connect the other end to the wall socket yet.
3. Plug the power adaptors into the mains wall socket and
switch the power on. The green POWER/IN USE light on
the base comes on.
4. Install 2 X NiMH AAA batteries supplied into each
handset. Then slide the battery compartment cover into
place.
Getting started
Talk/Standby time
Under ideal conditions, the
handset batteries should give
about 12 hours talk time or 120
hours standby on a single charge.
(The base must remain plugged
into the mains at all times).
Please note that new NiMH
batteries do not reach full capacity
until they have been run down and
recharged a few times.
Battery low warning
When the handset battery symbol
is empty and flashing, you will
need to recharge the handset
battery before using it.
+
–
–
+
5853 BT Freestyle 4100 UG [3] 12/1/04 12:47 pm Page 8