Filter
Top Products
JC; Reviewed:
SPOC 6/16/2011
Solution & Interoperability Test Lab Application Notes
©2011 Avaya Inc. All Rights Reserved.
14 of 30
IPTM96-CM601
5.4. Configure RTCP Monitoring
To allow PROGNOSIS IP Telephony Manager to monitor the quality of IP calls, configure
Communication Manager to send RTCP reporting to the IP address of the PROGNOSIS server.
This is done through the SAT interface.
Step
Description
1.
Enter the change system-parameters ip-options command. In the RTCP MONITOR
SERVER section, set Server IPV4 Address to the IP address of the PROGNOSIS IP
Telephony Manager server. Set IPV4 Server Port to 5005 and RTCP Report Period
(secs) to 5.
change system-parameters ip-options Page 1 of 3
IP-OPTIONS SYSTEM PARAMETERS
IP MEDIA PACKET PERFORMANCE THRESHOLDS
Roundtrip Propagation Delay (ms) High: 800 Low: 400
Packet Loss (%) High: 40 Low: 15
Ping Test Interval (sec): 20
Number of Pings Per Measurement Interval: 10
Enable Voice/Network Stats? n
RTCP MONITOR SERVER
Server IPV4 Address: 10.1.10.124 RTCP Report Period(secs): 5
IPV4 Server Port: 5005
Server IPV6 Address:
IPV6 Server Port: 5005
AUTOMATIC TRACE ROUTE ON
Link Failure? y
H.323 IP ENDPOINT
H.248 MEDIA GATEWAY Link Loss Delay Timer (min): 5
Link Loss Delay Timer (min): 5 Primary Search Time (sec): 75
Periodic Registration Timer (min): 20
Short/Prefixed Registration Allowed? N
2.
Enter the change ip-network-region n command, where n is IP network region number
to be monitored. On Page 2, set RTCP Reporting Enabled to y and Use Default Server
Parameters to y.
Note: Only one RTCP MONITOR SERVER can be configured per IP network region.
change ip-network-region 1 Page 2 of 20
IP NETWORK REGION
RTCP Reporting Enabled? y
RTCP MONITOR SERVER PARAMETERS
Use Default Server Parameters? Y
3.
Repeat Step 2 for all IP network regions that are required to be monitored.