Filter
Top Products
Basic Operations Guide
Section 6
1515
Call a Skype™ user
name using speed-dial
1. Pick up telephone handset connected to the WIP20.
2. Listen for the dial-tone.
3. Dial the two-digit speed-dial number, followed by “#”.
Example: 00#
Assign a Skype™ user
name to a speed-dial
using Auvi Interface
Below are the basic operations to make and receive calls from the phone connected to the WIP20.
NOTE:
Calls can be initiated and received through the Skype software and transfered to the phone
handset.
Double-click the contact to call or after answering an incoming call, pick up the handset. You will
hear a background tune (this is the dial tone if placing a call through the phone). Simply push the *
button to cancel the tune and start/continue your conversation.
1. Open the Auvi Interface and click “Contacts”.
2. Click New and fill in the necessary text fields.
3. Click Save.
End a call
When you wish to end a call, simply hang up the
handset.
Put call on hold
To place a caller on “Hold”, simply locate and press the “Flash” button
on your telephone. To continue the call, press the “Flash” button
again.
Receive incoming calls
Pick up telephone handset connected to the WIP20.
Make a call to an
ordinary phone number
This option requires
SkypeOut, a paid
service from
Skype™.
1. Pick up telephone handset connected to the WIP20.
2. Listen for the dial-tone.
3. Dial country code + area code + seven digit phone number + “#”.
Example (U.S. phone number): 15555555555#
Example (Hong Kong phone number): 852123456789#
NOTE: The “#” key must be pressed to connect the call.
Other Skype™ software
features not using a
telephone connected to
WIP20
Visit www.skype.com.