Filter
Top Products
-12-
VOX Delay
The VOX delay, like the VOX sensitivity, is preset at the factory
.
Roger Beep Tone
The unit will also transmit a beep tone sequence after each transmission to
signal the receiving party that transmission has ended. This tone is called a
“Roger Beep”. Press the Function (F) button five times until the ( RGB ) icon
flashes and oN or oF appears. Then press Up (
) or Down ( ) button to set the
function on. The ( RGB ) icon will remain displayed. To disable the “Roger
Beep”, proceed as before, until Beep Tone icon appears flashing. Then press
Up (
) or Down ( ) buttons to set the function to off. Press the PTT button to
confirm your selection.
Button Confirmation Tone
Whenever the Up/Down or Function (F) select button is pressed, the speaker will
sound a beep tone to confirm each press, provided the key tone feature is
enabled. To disable the key tones, press Function button six times until the
Beep Tone icon (
) appears flashing and oN or oF appears. Then press Up
(
) or Down ( ) to set the function off. Press the PTT button to confirm your
selection. When oF is selected, no beep tones should be heard. To enable the
key tones proceed as before, until Beep Tone icon appears flashing. Then press
Up (
) or Down ( ) button to set the function to on and the beep tones will be
heard.
Key Lock
This feature prevents accidental change of unit settings. While enabled, Key
Lock allows only the PTT button to operate.