Filter
Top Products
GX2400 English I/B ver. 09020A-1
09020A-1 12
OWNER’S MANUAL#GX2400VER.09020A-1
PAGE: 12 U.S. English Version
5. Press a number (0 through 9) where you want to store the phone number.
NOTE: You will hear a long beep to confirm that the number was properly stored.
6. Repeat procedures 1 to 5 to store other telephone numbers.
B. RECALLING A TELEPHONE NUMBER FROM MEMORY
1. Press the TALK button.
2. Press the MEMO button.
3. Select and press one of the keypad buttons (0 to 9). The stored telephone number will be
dialed automatically.
C. CHANGING STORED TELEPHONE NUMBERS
• Follow the steps described in “Storing Telephone Numbers. The new phone number will
automatically replace the previous one.
MIXED MODE DIALING (Temporary Pulse to Tone Dialing)
1. If you only have pulse (rotary dialing) service in your area and want to access Tone
services (Bank by Phone, etc.), ensure that the Tone / Pulse switch is set to the Pulse
position.
2. Press the TONE (*) button once to switch from Pulse to Tone dialing temporarily. Pulse
dialing mode resumes when the call is ended.
PAUSE FUNCTION
• In some cases, such as PABX or long distance service, a pause may be needed in the
dialing sequence. Pressing the handset RE / PA button inserts a four-second delay
between dialed numbers.
• Each four-second pause occupies one digit of the available 16 digits per memory
location.
FLASH FUNCTION
• Used to access custom calling features such as Call Waiting or Three-Way Calling
provided by your local phone company. Consult your local phone company for more
details.
CHANNEL SELECTION (40 Channels)
A.
AUTO CHANNEL SCAN
• When you place or receive a call and handset TALK button is pressed, the GX2400
auto-scans for the best channel available.
•
Once it finds a clear channel, the base unit and handset IN USE LED indicator will light
up.
B. MANUAL CHANNEL SCAN
• If the existing channel becomes noisy or starts having interference, press the SCAN
button on the handset repeatedly until a clear channel is found.
OUT OF RANGE WARNING
•
The handset and base unit communicate up to a certain maximum range. The distance
can be affected by weather, power lines, or even other cordless telephones.
• If you are far away from the base unit, the handset emits three beeps every 2 seconds to
warn you that the background noise level is too high for proper communication between
the handset and the base unit.
• When you hear this sound, you should move closer to the base unit to reduce the noise
level. Otherwise, the call will automatically cut off after 28 seconds.
NOTE: Excessive static for more than 28 seconds can cause the handset to lose link with the
base. Return the handset to the cradle to re-establish the security link.