Filter
Top Products
GX2400 English I/B ver. 09020A-1
09020A-1 8
OWNER’S MANUAL#GX2400VER.09020A-1
PAGE: 8 U.S. English Version
end to the telephone modular jack. (Figure 3)
WALL USE:
A. WITH A STANDARD AT&T OR GTE MODULAR WALL JACK
1. Install the wall mount bracket at the position as shown in Figure 4.
2. Connect the short telephone line cord to the TEL LINE jack on rear of the base unit.
3. Connect the opposite end of the telephone line cord to the modular wall jack.
4. Align the wall mounting slots with the studs located on the modular wall plate and slide
the base down to lock in place.
Telephone Modular
Wall Jack
Studs
Wall Mount
Base Unit Wall Mounting Bracket
(Side View) Slots
(Figure 4)
NOTE:
If you do not have a standard modular wall jack, find a qualified technician to mount
one on the wall.
B. WALL MOUNTING (No Standard Wall Jack)
1.
Drill two holes with a vertical distance between the two marked
positions of 3 15/16” (100 mm) as shown in Figure 5.
2. Drive a screw into each of the holes. Tighten them to the end of the
screw line, only leaving the smooth part of the screw head outside
the wall.
3. Hang the unit onto the screws, and then slide it down firmly to
fasten the base securely. (Figure 5)
BASE RETAINER TAB
If the base unit is to be placed in the wall mount position, the base retainer tab allows the
handset to hang onto the base unit.
Retainer Tab