Filter
Top Products
128-7961
20 of 28
20
- If a stored memory channel is inactive for listening purposes, wait 5
seconds to see if it clears; and then proceed to the next available
channel signal using the auto scan feature.
NOTE: When the Scan (S) button is pressed during auto scan or manual
scan mode, the unit returns to the home channel.
Battery Alert
When the battery icon is empty ( ) and flashing on the display, recharge
unit or install fresh batteries.
The battery status is displayed in the top right corner of the LCD with
1,2 or 3 bars (1 bar = low charge, 3 bars = full charge).
Battery Charge Status and Charging Instructions
Initial Charging Sequence
1.Remove batteries from plastic wrapper.
2.Insert batteries into each radio, observing polarity.
3.Place each radio in the charger base (charging LEDs should be on)
4.Charge for 6-7 hours.
Charging Procedure:
The LED on the charger base will light red as the battery level is read.
There are three battery icon bar segments indicating the battery charge
level during charging:
Once the charge reaches the designated voltage, the slow-charging mode
will take effect:
1.The LED on the desktop charger will be off when the slow-charging
mode is in effect.
2.The battery icon on the LCD displays three bars to indicate a full
charge level.
3.After 3 hours, battery charging is complete.