Filter
Top Products
128-6781
5 of 16
Powering the Transceiver
Your GMRS200W radio transceiver operates on a Lithium ion
(Li-ion) battery.
Installing the Batteries:
To install the battery, proceed as follows:
1. Press the release clip lever toward the cover and lift the
battery cover up and off at the same time.
2. Insert the Li-ion battery with the contacts facing down and
touching the unit contacts.
3. Insert the end tab of the battery cover in the bottom slot
and press the top of the cover into position until it clicks into
place.
Charging the Transceiver Battery
PTT/CALL
MIC/CHG/SPK
JACK
ADAPTER
PLUG
CHARGING
LED (RED)
WALL CHARGING ADAPTER
GMRS2WCH
5
WRIST
BAND
POSITIVE
TERMINAL
RELEASE
CLIP LEVER
(TOP OF COVER)
BATTERY
COVER
NEGATIVE
TERMINAL
NOTE: The battery will fully charge in approximately 10-12 hours.