Filter
Top Products
TABLE/DESK INSTALLATION
This telephone includes a 7-foot line cord with a
modular plug on each end. Use this cord to connect
the telephone to a modular jack.
1 Fill in directory card
Remove the directory card and
write in your own telephone
number. Also write the
telephone numbers (or names)
that you want to store in each
memory location.
Reinstall the card and clear
plastic cover.
2 Connect line cord to telephone
Plug the long line cord into the
jack on the underside of the
telephone base. Then feed the
line cord through the channel
provided so the telephone sits
flat on your table or desk
during use (Figure 1).
3 Connect line cord to wall jack
Plug free end of the line cord
into a modular jack. Make sure
it snaps firmly into place.
4 Set DIAL mode switch
This product comes set in the
tone (TT) mode. Make sure
you choose the correct dialing method
(TT or DP); touch tone dialing will not
work if you have dial pulse service.
5 Connect handset to base
Plug one end of the coiled handset cord into the
handset, and the other end into the base. Then
hang up.
6 Check for dial tone
Lift the handset and listen for dial tone. If you
cannot hear a dial tone, refer to “In Case of
Difficulty” and try to correct the problem.
TO DISCONNECT the telephone, squeeze the
clip on the modular plug and pull it out of the jack.
Figure 1
Figure 2
1