Filter
Top Products
PLEASE WAIT...
HANDSET X
REGISTERED
8
PRESS HNDST LOC
4 SEC ON BASE
To register a handset to your telephone base
• When first purchased, all optional accessory
handsets show NOT REGISTERED on the
screen. The new handset may need to be
charged for five minutes before registering to
the telephone base.
• Make sure your handset battery is properly
installed and charged (pages 5-6).
• Place the unregistered handset into the
telephone base. After a few seconds
PRESS
HNDST LOC 4 SEC ON BASE
will be shown on
the screen.
• Press and hold HANDSET LOCATOR on the
main telephone base until the IN USE light
comes on (about four seconds), then release
the button.
• The handset will show PLEASE WAIT... for a
while.
• The handset will show HS X REGISTERED and will
beep if the registration was successful.
NOTE: If the registration is not successful, the display
will show NOT REGISTERED. Reset the handset by
lifting the handset out of the telephone base and
then place the handset back in the telephone base.
Now try the registration process again.
Getting started
Adding and registering handsets
NOT REGISTERED