Filter
Top Products
48
Appendix C
Handsets purchased separately need to be registered to
the telephone base before use. When first purchased, all
optional accessory handsets will show NOT REGISTERED on
the screen. The new handset(s) may need to be charged for
five minutes before registering to the telephone base.
NOT REGISTERED
Adding and registering handsets
Your telephone can accommodate up to twelve cordless handsets. You can add
new handsets (SL80108, sold separately) to the SL81108/SL81208 at any time,
but each new handset must be registered with the telephone base before use.
Each handset must be registered separately.
The handset provided with your SL81108 is automatically registered as handset 1.
Additional handsets will be assigned numbers in the order they are registered
(handset 2, handset 3, handset 4 and so on). You can register eleven additional
handsets.
The SL81208 has two handsets automatically registered as handset 1 and handset
2. You can register ten additional handsets, which will be assigned as handset 3,
handset 4 and so on.
To register a handset to your telephone base
1. Place the unregistered handset into the telephone base.
If PRESS HNDST LOC 4 SEC ON BASE does not appear
on the handset screen after a few seconds, remove the
handset and place it in the telephone base again.
2. On the telephone base, press and hold HANDSET
LOCATOR for about four seconds (until the red IN USE
light on the telephone base turns on) and then release
the button. The handset will show PLEASE WAIT... and it
will take about 10 seconds to complete the registration.
The handset will show HS X REGISTERED and will beep if
the registration is successful.
NOTES:
1. If the registration is not successful, the display will show NOT
REGISTERED. To reset the handset, remove the handset from the
telephone base and place it back in. Try the registration process again.
2. You cannot register a handset if any other system handset is in use.
PRESS HNDST LOC
4 SEC ON BASE
PLEASE WAIT...
HS X REGISTERED