AT&T EL52300 Cordless Telephone User Manual


 
44
Answering system
Answering system overview
Voice prompts
The system provides voice prompts to guide you through recording
announcements and remote access.
Message capacity
The answering system can record up to 99 messages, depending on the
length of each message. Individual messages can be up to four minutes, and
the approximate recording time is 11 minutes. The actual recording time
depends on individual message characteristics. Messages remain available for
replay until you delete them.
If the answering system has less than three minutes of recording time left,
the remaining time is announced at the end of messages playback.
If the memory is full, the answering system announces, “Memory is full.” The
number of messages and F flash alternately in the message window, and
REC MEM FULL appears on the handset screen. You must delete some
messages before recording new ones.
Call screening
If the answering system and call screening are on, the announcement and
the incoming message broadcast at the telephone base when a call arrives.
You can turn call screening on or off using the handset
(see Call screening setup on page 17). When call
screening is off, you can temporarily turn on call
screening by pressing PLAY/STOP or VOLUME on
the telephone base. The call screening will be off for the
next incoming call.
If call screening is on and you want to adjust the
playback volume to a comfortable level (1-8) while it is recording messages,
press VOLUME on the telephone base. This volume setting is shared with
message playback, so when you play messages at volume 1, they play at a
very low volume. If you turn up the volume for playback, the call screening for
the next incoming message plays at the same volume level.
If call screening is on and you want to silence the telephone base while
it is recording messages, press PLAY/STOP on the telephone base. Call
screening will be on for the next incoming call.