Filter
Top Products
5
Battery charging
Once you have installed the battery, the screen indicates the
battery status (see the table below). If necessary, place the handset
in the telephone base or charger to charge the battery. For best
performance, keep the handset in the telephone base or charger
when not in use. The battery is fully charged after 16 hours of
continuous charging. See page 27 for battery operating times.
If the screen is blank, you need to charge the handset without
interruption for at least 30 minutes to give the handset enough charge to use the
telephone for a short time. The screen shows LOW BATTERY until you have charged the
battery without interruption for at least 30 minutes. The following table summarizes the
battery charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank or shows
PLACE IN CHARGER.
The battery has no or very
little charge. The handset
cannot be used.
Charge without interruption
until the screen shows
LOW BATTERY or HANDSET X
(at least 30 minutes).
The screen shows
LOW BATTERY and flashes.
The battery has enough charge
to be used for a short time.
Charge without interruption
until the screen shows
HANDSET X (at least
30 minutes).
The screen shows HANDSET X
and the battery icon shows
, or .
The battery is charged. To keep the battery charged,
place it in the telephone base
or charger when not in use.
NOTES:
If you are on a call in low battery mode, you hear four short beeps every 50 seconds.
When you place the handset in the telephone base or charger, if no battery is installed in that
handset, the CHARGE light is off and the screen shows NO BATTERY. Follow the instructions in
Battery installation on page 4 to install the battery.
•
•
Battery status icon
11/20
HANDSET 1
16 MISSED CALLS
10:30
PM