Filter
Top Products
43
Appendix
Adding new handsets
Your telephone can accommodate up to four cordless handsets. You can add new
handsets (E597-1, sold separately) to the E5926, E5927B, E5937B and E1937B at any
time, but each handset must be registered with the base before use.
The handset provided with your E5926 is automatically registered as handset 1.
Additional handsets will be assigned numbers in the order they are registered (handset
2, handset 3, or handset 4). You can register a maximum of four handsets.
The E5927B has two handsets automatically registered as handset 1 and 2. You can
register two additional handsets, which will be assigned number 3 and 4.
The E5937B/E1937B has three handsets automatically registered as handset 1, 2 and 3.
You can register one additional handset, which will be assigned number 4.
The E5947B has four pre-registered handsets, so you cannot register any additional
handset to it.
Handset 1 Handset 2 Handset 3
Handset 4
Before using a new E597-1 handset, you must register it
with the base.
To add a new handset:
• When first purchased, all optional accessory hand-
sets show NOT REGISTERED on the screen.
• Make sure your handset battery is properly installed
and charged.
• Put the handset in its charger which is plugged into
AC power. After a few seconds
PRESS HNDST
LOC 4 SEC ON BASE
will be shown on the screen.
• Press and hold HANDSET LOCATOR on the main
telephone base until the IN USE light comes on
(about four seconds), then release the button.
• The handset will show PLEASE WAIT... for a while.
• The handset will show HS X REGISTERED and beep
once if registration was successful.
NOTES:
1. You can register only one handset to the base at a time.
2. If you are on a call, using the call log or directory, or another phone is on
the same line, you cannot register a handset.
3. If the registration is not successful, the display will show NOT
REGISTERED. Reset the handset by lifting the handset out of the cradle
and then place the handset back in the cradle. Now try the registration
process again.
HS X REGISTERED
NOT REGISTERED
PRESS HNDST LOC
4 SEC ON BASE