Filter
Top Products
Installation & setup
After battery installation, place the cordless handset in the charger and allow to charge
for at least 16 hours before use. You can keep the battery charged by returning the cord-
less handset to the charger after each use. When the battery is fully depleted, a recharge
takes about 12 hours. The average talk time on a fully charged battery is about five hours
depending on environmental conditions, and the standby time is approximately five days.
Plug the battery
connector into the
handset.
Place handset in
charger for at least
16 hours before
first use.
Plug power adapter
into jack on under-
side of charger as
shown, then plug
into an electrical
outlet not controlled
by a wall switch.
Place the battery
pack and wires in
the compartment.
Caution: Use only the supplied rechargeable battery pack or AT&T replacement battery model 3301 (SKU 91076.
Part number 80-5071-00-00).
Plug the large
power adapter
into an
electrical outlet
not controlled
by a wall
switch.
Plug long
telephone
line cord into
telephone
jack.
Plug handset
cord into
handset and
jack at the
bottom of the
base.
Press in and downward on
the tab to open the battery
compartment cover.
Slide battery com-
partment cover up
until it clicks closed.