Filter
Top Products
7
Getting started
1. Plug the small end of
the smaller power adapter
into the jack on the under-
side of the charger, then
route the cord through the
slot as shown.
"!44%29,/7
AM
.%%$32%#(!2').'
then
Battery installation & charging
After installing the battery, you may be able to make or receive short calls. For
best performance, place the handset in the telephone base or charger to charge
for 16 hours before use.
You can keep the battery charged by returning the handset to the telephone base
or charger after use. When the battery is fully depleted, a recharge takes about 12
hours. The average talk time on a fully charged battery is about five hours, and the
Ɠɇ-
ditions and age of battery.
3. Insert the plug as indicat-
ed. Be sure to securely insert
the plug, making sure that it
matches the color-coded label
inside the battery compart-
ment.
6. You may be able to make or receive
short calls. For best performance, place the
handset in the telephone base or charger to
charge for at least 16 hours before first use.
Caution: Use only the supplied rechargeable battery, replacement battery 2422 (SKU 23402, part
number 89-0047-00-00) or equivalent. To order a replacement battery, visit our
website at www.telephones.att.com or call 1 (800) 222-3111. In
Canada dial 1 (866) 288-4268.
To replace the battery,
press in and downward
on the tab of the bat-
tery compartment to
open the battery com-
Ɠ
out the old battery
and disconnect it from
the handset. Follow
the instructions on
this page to install and
charge the new battery.
5. Slide the bat-
tery compart-
ment cover up
until it clicks.
Battery low indicator
telephone base or charger
to recharge when this sym-
bol flashes and the handset
beeps or when the hand-
set screen displays NEEDS
RECHARGING.
4. Place the bat-
tery and wires
inside the com-
partment.
2. Plug the large
end of the smaller
power adapter into
an electrical outlet
not controlled by a
wall switch.
NOTE: Under normal conditions, the
battery should last around one year. This
may vary depending on usage.