Filter
Top Products
21
Telephone operation
Handset settings
To cancel an operation, back up to the previ-
ous menu, or exit the menu display press
OFF/CLEAR. To return to the idle mode press and
hold OFF/CLEAR.
Dial type
In this menu, you can choose TONE or PULSE
(rotary) dialing. The factory default setting is TONE.
Change this to PULSE only if you do not have
touch-tone dialing service.
1. Press MENU/SELECT in idle mode to enter the
feature menu.
2. Use the CID/-VOLUME or DIR /VOLUME+ to scroll
to the DIAL TYPE menu, press MENU/SELECT to
enter the menu when it is highlighted with a >
symbol.
3. Press the CID/-VOLUME or DIR /VOLUME+ to
select TONE or PULSE.
4. Press MENU/SELECT to save your preference and
be returned to the feature menu.
NOTE: If you have more than one handset registered, dial
type change made on any one handset will apply to all.
Temporary ring silencing
Press OFF/CLEAR or MUTE/DELETE while the tel-
ephone is ringing to silence the ringer temporarily.
This will silence the ringer without disconnecting
the call. The next incoming call will ring normally
at the pre-set volume.
NOTE: If there is more than one handset in use, all hand-
sets ring with an incoming call except those with the vol-
ume turned off. Press OFF/CLEAR or MUTE/DELETE on
one handset will only silence the ringer of that particular
handset but the other handset(s) will continue to ring.
DIAL TYPE: TONE
>
DIRECTORY
>
DIAL TYPE