Filter
Top Products
4
Table/Desk Installation
1 (Optional) You can adjust how much the phone tilts by pushing
outward with your thumbs on the recessed “feet.” Push the feet
out from the inside of the base,until they snap into place. If a foot
comes out, align the arrow on the foot with the arrow on the base,
and squeeze the foot back in from the inside of the base.
4 Connect the line cord to the telephone.
5 Thread the power cord through the strain-relief tab,
then plug it into the jack labeled POWER.
(Make sure the plug is vertically oriented.)
Use only the power cord supplied with this product.
If you need a replacement,call 1 800 222-3111.
INSTALLATION
3 Attach the base to the
telephone.
Turn the base so that the
smaller end is toward the
bottom of the telephone,
then attach.
2 Set the dial mode.
This phone comes set for
touch tone dialing (TT). If
you have dial pulse (rotary)
service, set the swich on the
underside of the phone to DP.
957_book_2ATT ill at margins 11/16/00 1:39 PM Page 4