Filter
Top Products
INSTALLATION
4
3 Reverse handset tab.
To mount the telephone on a wall, you must
reverse the handset tab. This tab holds the
handset when you hang up.
Hold down the switchhook, and slide the tab
up and out of its slot. Turn the tab so that the
curved end is up. Insert the tab back into its slot.
1 Connect bundled line cord(s) to the telephone.
Leave the telephone line cord(s) bundled.
• If you have a two-line wall jack, use only
the line cord with the clear modular plugs on
each end. Plug one end into the jack labeled
L1 OR L2 on the back of the telephone.
Place the bundled line cord in the open area
under the set.
• If you have two separate wall jacks, use
both line cords.
Leave the cord with
the blue plugs
bundled. Plug one
end of this cord into
the jack labeled L1
OR L1/L2 on the
back of the
telephone.
Unbundle the cord
with the clear plugs. Plug one end of this
cord into the jack labeled L2 on the back of
the phone. Rebundle the cord and store it in
the open area under the set.
2 Attach the base.
Turn the base so that the larger end of the base
is toward the bottom of the telephone. Attach
the base by inserting the tabs into the slots.
Push down on the large end of the base to lock
it into place.
Wall
4 Connect the line cord(s) to modular wall
jack(s) and mount phone onto wall jack.
• If you have a two-line jack, plug the free
end of the line cord into the modular wall
jack. Make sure the cord snaps firmly into
place. Place the phone on the wall jack
mounting studs and pull down until it is
held securely.
• If you have two separate jacks, plug the
free end of the cord with the blue plugs into
the jack for Line 1. Plug the free end of the
cord with the clear plugs into the jack for
Line 2. Make sure the cords snap firmly into
place. Place the phone on the wall jack
mounting studs and pull down until it is
held firmly in place.
Follow Steps 4 through 7 under Table Installation.