Filter
Top Products
INSTALLATION
4
Use only the power cord supplied with this product. If you need a
replacement, call 1 800 222-3111.
3 Charge the handset battery.
Place the handset in the base. Charge the battery for at least 24 hours
the first time. After the first charge, the battery is typically fully
charged overnight.
4 Check for dial tone.
After the batteries are charged, pick up the handset and press P;
you should hear a dial tone.
5 Set the dial mode.
If you have touch tone service, the phone is ready to use as soon as the
batteries are charged.
If you have dial pulse (rotary) service,you’ll need to change the dial mode.
When the phone is off, press P,*, #, P to set the dial mode to
dial pulse. To return to touch tone dialing,press P, *, *, P.
Standard
electrical outlet
Modular
telephone
jack
Table/Desk Installation
1 Connect the
telephone
line cord.
2 Connect the power cord. The
ANSWER ON/OFF light goes on, and CL
flashes in the Message Window.
9351_book_2ATT 1/1/01 3:33 PM Page 4