Filter
Top Products
7
Reverse the handset tab. This tab holds the handset when you
hang up. Hold down the switchhook and slide the tab up and
out of its slot. Turn the tab so that the end with the hook is
up. Then hold down the switchhook while you insert the tab
back into its slot.
Connect the handset to the telephone. Plug the handset coiled
cord into the handset jack on the left side of the telephone
base. Plug the other end of the handset coiled cord into the
handset, then hang up.
Connect the telephone line cord to a telephone wall jack and
mount the telephone on the wall jack as shown below.
Make sure the cord snaps firmly into place. Place the telephone on
the wall jack mounting studs and pull down until it is held securely.
Check for a dial tone. Lift the handset or press to listen for
a dial tone. If you cannot hear a dial, slide HS VOL (handset
volume) or SPK VOL (speakerphone volume) upward. If you
still do not hear a dial tone, see the Troubleshooting section
on page 14 of this user's manual.
5.
6.
7.
8.
Installation
Switchhook
Handset tab