Filter
Top Products
Switch Features
Since your 8510T voice terminal is connected to a DEFINITY Communications
System Generic 1 or Generic 3, you may be able to use some of the following
features. Check with your System Manager to see which of these features have been
assigned to your voice terminal.
Special Instructions
Before you use these procedures for the first time, read the general directions below
for using the many features of DEFINITY Generic 1 and Generic 3. Your System
Manager can supply the information required.
●
●
●
To the right of each of the feature name is a box. Check with your System
Manager to see which features you can use at your voice terminal. For each
feature that you have, mark a [
✔ ] in the blank box as a reminder.
You can activate or cancel most of the features by dialing unique 2- or 3-digit
codes for that feature. Ask your System Manager for the feature codes for your
system. Then, in the blanks provided within the procedures, write in the
assigned feature code numbers.
In many case, before you begin a procedure, you must have the handset off-
hook (removed from the cradle of the voice terminal).
If you receive an intercept tone (high-pitched, alternating high and low tone)
●
while attempting to operate any feature, you have taken too much time to
complete a procedural step or have made a dialing error. Hang up, wait for
dial tone, and begin again at Step 1.
Conventions
The following conventions are used in the procedures in this section:
Gray Type
Procedural steps in gray type are steps that you
should follow if you do not have a button assigned for
the feature.
[ xxxxx ]
This box represents a call appearance button, which is
used exclusively for placing or receiving calls. The
button has a red in-use light and a green status light
and is labeled with an extension number (shown as
xxxxx).
11