Filter
Top Products
Making A Call
1 Press P, and wait for the
PHONE light to go on steadily.
2 When you hear a dial tone, dial the
number.
NOTE: You might experience a slight de-
lay before you hear a dial tone, as the
AutoSelect
®
feature searches for a clear
channel.
Answering a Call
If this phone is ringing and the handset
is in the base, lift the handset. The PHONE
light goes on, and the call is connected.
NOTE: If the ringer switch is set to OFF,
press
P
to answer the call.
• If the handset is out of the base,
press P. The PHONE light
goes on, and the call is connected.
• Although ringing stops when you
answer, you might not be able to
hear the other party until the
PHONE light goes on steadily.
Ending a Call
To end a call, place the handset into the base
or press P.
Redial
The last number dialed (up to 16 digits) on
this phone is stored in redial memory until
you dial another number.
1 Press P, and wait for the
PHONE light to go on.
2 When you hear a dial tone, press
R.
Battery Saver Control
Feature/Ringer ON-OFF
Set the switch on the side of the handset to
OFF to prevent the handset from ringing.
When the ringer switch is set to OFF, the
handset stays ready to use for up to 21 days
in standby mode before you have to return it
to the base for recharging. You can still use
the handset to make a call or to answer a call
if you hear an extension phone ringing.
When the ringer ON/OFF switch is set to
ON, the handset stays ready to use for up to
14 days in standby mode.
Handset Volume
The handset volume can be set to three dif-
ferent levels. Each time you press V the
level changes.
Temporary Tone
NOTE: If you have touch tone service, you do
not need to use the Temporary Tone feature.
If you have dial pulse (rotary) service, this
feature allows you to enter codes or tones
needed to operate answering machines, or to
use electronic banking services, calling cards,
and other special services. This feature will
operate most special services; however, some
services may actually require a touch tone
line. To be sure, ask the company that
provides the special service.
1 Dial the call, then press * (tone). Any
dial buttons pressed after this send
tone signals.
2 After you hang up, the phone auto
matically returns to dial pulse (rotary)
dialing
Mute
Mute allows you to hear your caller, but pre-
vents the caller from hearing you.
While on a call:
• Press M. The MUTE light goes on.
To deactivate the Mute feature :
• Press M again. The MUTE light
goes off.
Flash
Press F to activate custom-calling
services such as Call Waiting or 3-Way
Calling. You may have to press other
buttons before or after F as explained
in custom-calling instructions provided by
your local telephone service company.
OPERATION
Light is on while
you're on a call.
Make and answer calls.
Temporary Tone
Change channels.
Store/access numbers
in memory locations.
6