Filter
Top Products
INSTALLATION
AC Adapter
Modular Wall Jack
Standard AC Outlet
Power Cord
Telephone Line Cord
groove on the bottom of the base.)
Plug the other end of the line cord
into a modular phone jack. Make
sure the plug snaps firmly in place.
6 Mount the base on the wall
(WALL MOUNTING ONLY)
Hold the base so that the mounting
knobs on the standard wall jack will
fit into the holes on the bottom of
the base. Slide the base down onto
the knobs until it locks into place.
7 Connect the power cord.
Plug the power cord into the jack
labeled POWER on the back of the
base. Plug the AC adapter on the
power cord into an electrical outlet.
The microcassette will automatically
rewind. When the tape stops moving,
the light above the
PLAY/STOP
button.
track up over the battery case
until it snaps firmly in place.
4 Set the Handset Ringer ON/OFF
switch. Set the switch on the side of
the handset to ON so the handset
will ring. When this switch is set to
OFF the handset will not ring.
NOTE: If you set the Ringer ON/OFF switch
to OFF, the handset battery will last longer.
However, when the ringer is set to OFF, you
will always need to press
P
to answer a
call, even when the handset has been in the
base.
5 Connect the telephone line cord.
Plug one end of the telephone line
cord into the jack on the back of the
base. (If you are wall mounting the
phone, wrap the excess cord in the
1 Insert the microcassette.
Lift the cover and insert the
microcassette with the full reel to
the right.
2 Choose a spot near an electrical
outlet and a telephone jack.
• This phone requires a modular
telephone jack and a standard
electrical outlet (120v AC).
3 Install the handset battery.
(For an illustration of battery installa-
tion, see “BATTERIES.”)
• Plug the battery pack connector
into the handset and place the
battery pack into the case, so the
wires rest above the battery
pack.
• Place the battery case cover on
the handset by sliding it on its
1