Filter
Top Products
6
Wall Installation
1 Connect the power cord and
telephone line cord to the underside
of the base, as shown (figure a).
2 Position the mounting bracket as
shown (figure b).
3 Feed the telephone line cord through
the hole in the center of the mounting
bracket (figure b), align the bracket
with the base, and slide it into the
hole on the base as shown (figure c).
4 Lock the mounting bracket in place
(figure d).
5 Plug the telephone line cord into a
modular wall jack, and mount the
base on the wall (figure e).
a) Align holes on base with mounting
studs on wall jack.
b) Place power cord as shown.
c) Pull base down on mounting studs until
it locks into place.
6 Plug the power cord into an electrical
outlet not controlled by a wall switch
(figure e).
Use only the power cord supplied
with this product. If you need a
replacement, call 1-800-222-3111.
7 Follow Steps 3–5 in “Table/Desktop
Installation.”
figure a
figure b
figure c
figure d
figure e
INSTALLATION
INSTALLATION
91-5438-20-00_ATT3358_R0 2003.7.11 9:41 AM Page 6