Filter
Top Products
For Table/Desk and Wall Installation
Coiled cord
7
INSTALLATION
1 Plug the coiled cord
into the jack on the
base. Plug the other
end into the handset,
then hang up.
2 Lift the handset and
listen for a dial tone.
If you can’t hear a dial
tone, see IN CASE OF
DIFFICULTY.
3 Set RINGER switch to
LO, HI or OFF. If the
RINGER switch is set
to OFF, you will not
hear this phone ring
when you have an
incoming call.
Your phone will work immediately after installation using the default
feature settings (see Feature Settings Summary on next page). You can
make and answer calls as soon as the phone is connected to a telephone
jack,but you must install the batteries for the screen,Caller ID features
and memory to work (see “Battery Installation”).
NOTE: If you subscribe to Caller ID services from your local telephone
service provider, you must follow the instructions in “Set Home Area
Code” on page 11 for your phone to properly recognize and dial calls,
and you may need to follow the instructions in “Set Local Area Codes”
on page 12.
260book_1ATT 4/24 4/24/02 6:24 PM Page 7