Filter
Top Products
INSTALLATION
3
4 Charge the handset battery.
• Place the handset in the base (or the spare charger).
• Charge the battery at least 12 hours. After the first charge, the
battery will charge in eight hours.
5 Check for dial tone.
• After the batteries are charged,lift the handset and press P;
you should hear a dial tone.
Spare Charger Installation
1 Connect the power cord attached
to the spare charger to an
electrical outlet not controlled by a
wall switch.
2 Follow Steps 3–5 in “Base
Installation.”
Belt Clip
Attach belt clip to
the cordless
handset (optional).
Headset
You can use this telephone hands-free
when you install any AT&T 2.5 mm
headset (purchased separately).
Plug the headset into the jack located
on the right side of the handset
(under the small rubber flap). Do not
force the connection, but make sure
the plug fits securely.
a) Slide down
into grooves
to attach.
b) Push up
and away
to remove.