Filter
Top Products
5
Connect Equipment and Power
The PowerShield battery charges when it is connected to utility power. The battery
charges fully during the first eight hours of normal operation. Do not expect full battery
run capability during this initial charge period.
1. Connect the PowerShield to the application equipment (example: FTTH/P Optical Network
Terminal) via the seven-pin output connector, using the appropriate cable (must be ordered
separately). See www.apc.com
for a list of available output cables.
2. Plug the PowerShield power cord into the utility power cord inlet and then into the wall outlet.
Do not overload the wall outlet or circuit.
Cold Start Feature: Upon installation of a charged battery, power will immediately be applied to
the unit even when utility power is not present.
Optional Runtime Extension
The runtime may be extended by adding the external battery CP20B12BP.
Output Power and
Communication
Signals
Utility Power
Cord Inlet
Optional Runtime
Extension Connector