Filter
Top Products
CHAPTER 5
(CONTINUED)
Voice Activated answering (DIALOGUE
RC
–200 only)
1. The voice activated Answering feature
has been preset to OFF in the factory.
To activate this feature, see page 5.
2. Say "Hello" or whistle loudly, between
rings. (If a headset is used, answer by
speaking into the headset microphone.)
3. Use the remote control, or press the
ON/OFF button on the console to hang up.
Please Note: When the party that called
you hangs up, the telephone company
switching office may re-establish a dial
tone on your line.
When dial tone returns, your
RC
–200
will hang up automatically. Prior to
hanging up, the
RC
–200
emits two
short beeps as a reminder.
D. Other Operations
Redialing the last number dialed
1. Press the REDIAL
button on the keypad.
OR
2. Press and hold the
Remote Transmitter for
3 seconds, until the
ON/OFF indicator on
DIALOGUE
RC
turns on.
Flash button
The flash button is used to access special tele-
phone functions and services available from
your local phone company, such as call waiting,
3–way calling, and others. Call your phone
company for more information.
FLASH/PAUSE
REDIAL
MUTE
ON/OFF
HEADSET
MIC
Figure 20
FLASH/PAUSE
REDIAL
ON/OFF
Figure 21
If you have the DIALOGUE
RC
–200, you can
use the Flash feature with the Remote Transmit-
-ter. Turn the Remote Flash switch on (see
Chapter 4 section C). When you are on the
phone line, press the Remote Transmitter button
twice in succession, within three seconds, to
generate the “flash”.
Voice Mail Indicator (VMI)
If you subscribe to voice mail service from your
phone company, the FLASH/PAUSE light flashes
and the RC beeps (once every 3.5 minutes) to
inform you that you have voice mail messages.
You also hear a special "stut-
ter" dial tone sent from the
phone company. To retrieve your
messages,
follow the instructions
provided by your phone
company. Making an
outgoing call cancels the
indicator light.
Unanswered Call Indicator
If the DIALOGUE
RC
rings
three or more times and is not
answered, the FLASH/PAUSE
light flashes to indicate that you
missed a call.Turning on the DIALOGUE
RC
cancels the indicator.
Telebanking and Credit Card Calling
You can transmit account or personal
identification numbers (PIN) from the
DIALOGUE
RC
by pre–storing them in memory.
1. Program account or PIN numbers into
a memory location in advance by
following the same steps you would
program a phone number.
2. When the automated phone system
requests it, press the memory button
where your account number or PIN is
stored.
REDIAL
M
UTE
ON/OFF
A
DSET
FLASH/PAUSE
REDIAL
M
UTE
ON/OFF
A
DSET
FLASH/PAUSE
Figure 22
Figure 23
8