Filter
Top Products
ALPINE DCS-BT1 USER GUIDE ALPINE DCS-BT1 USER GUIDE
Handsfree Connection
To install the Alpine DCS-BT1 in your car, rst place the metal visor clip onto
the back of the Alpine DCS-BT1, then secure Alpine DCS-BT1 to the sun visor
in your car as shown below.
Installing in car
8
9
1. After pairing, Alpine DCS-BT1 connects automatically to your handset.
If the devices are paired but not connected, press the Activity button.
2. If the devices are disconnected, you will hear the voice prompt
“Phone disconnected”.
The handsfree will remain in auto reconnection mode for 30 minutes.
NOTE
When disconnected from your handset, the handsfree turns
o automatically after 30 minutes.
DCS-BT1 Operation
Making a call
1. Last number redial
Press and hold the the Activity button for 1 second to activate last number
redial. (Some handset will show the list of calls.)
2. Voice dialing
Briey press the Activity button to activated 'voice command'.
Tip
Your handset must support the ‘voice dial’ function.
Answering a call
Briey press the Activity button to answer an incomming call.
Ending a call
Briey press the Activity button.
You will hear the voice prompt “End of call”.
Tip
During an incoming call, you will hear the voice prompt
“Call from XXXXXXXX”.
Caller ID