Aiphone JA-DGV Intercom System User Manual


  Open as PDF
of 3
 
SPECIFICATIONS
Power Source: Supplied by master station.
Consumption: 370mA (max.) 4.5mA (Standby, approximate)
Picture element: CCD camera
Image view area Vertical Horizontal
(approx.): In horizontal position: 18" 26"
When pan-and-tilted: 3' 6'
Min. illumination: Less than 1 Lux (at 20" from camera).
Ambient temperature: 14° F ~ 140° F.
Wiring: 2 parallel wires, non-polarized to master. PE Insulated, low capacitance.
Use Aiphone wire # 871802
Wiring distance: AWG 22AWG 18AWG
Distance 165' 330'
Dimensions: (HxWxD) 10-3/16" x 7-5/16" x 5/8" (outer panel dimensions)
Mounting: Flush mount: 9-1/16" x 6-1/8" x 2-11/16" (ABS plastic back box is included)
Surface mount with SBX-DGV: 10-3/8" x 7-7/16" x 3-¼” (top), 2-½” (bottom)
Weight (approx.): 1.90lbs
Aiphone Communication Systems
1700 130th Ave. N.E.
Bellevue, WA 98005
(425) 455-0510
FAX (425) 455-0071
Pg. 3
JA-DGV instr.
1206JD
Note:
Only information pertaining to the connection and operation of the JA-DGV and devices interfacing with it are
included here. For complete installation, wiring, and operational information about the JA system, please refer
to the Installation Manual included with the monitor.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device , pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try and correct the interference by one or more of the following measures:
— Reorient or locate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
FCC Class B Verification
TOLL FREE TECHNICAL SUPPORT:
(800) 692-0200
E-MAIL: tech-serv@aiphone.com
 previous