Aiphone JA-2MECD Intercom System User Manual


 
- 7 -
Answering a door call (AUTO mode)
The station is initially set to AUTO voice switch activation.
1. Momentarily press CALL button.
2. Chime tone sounds, and the monitor turns on with callers
image. Door call-in LED 1 or 2 is lit.
3. Press TALK button momentarily and reply handsfree.
4. When finished, press TALK button once to turn off.
Timer; Call-in, 30 sec. Communication, 1 min. (approx.). Press
TALK button to turm back on (if within 30 sec.)
7-4
Instant voice calling for family use
1. Momentarily press CALL button.
2. When chime sounds, the monitor turns on with the image of
the caller. Sound from the entry area is heard through the
speaker of the inside station(s).
Note: Not available on JA-D door station.
7-2
7-3
Monitor a door station
1. Momentarily press MONITOR button.
2. Video monitor turns on image of DOOR 1.
3. Press MONITOR button again to switch to DOOR 2.
4. Press MONITOR button to end monitoring.
Notes:
Inside audio cannot be heard at door station.
Press TALK button to establish communication with door
station.
The image automatically turns off in approx. 30 sec.
When DOOR2 is audio-only type (JA-D), it is skipped while
monitoring and audio door cannot be monitored.
Pan and tilt the door station camera
The monitor station is equipped with Aiphone's exclusive Pan-
and-Tilt control pad. When the video door station is on, press on
each edge of pad to move the camera up down and right left.
7-1
7
OPERATIONS
Initial picture memory setting
Before use, be sure to program in the following manner:
1. Place the unit in SET mode. Press SET button and hold down
for more than 2 seconds. Both PLAY & REC buttons start
flashing.
2. Choose on-screen DATE location. As desired, move up with
PLAY button, and move down with REC button. Press SET
button to select. Next, 2003 flashes.
3. Set time in the order of; (1) Year, (2) Month, (3) Day, (4) Hour,
and (5) Minute. 1/JAN/04 0:00
4. Choose PICTURE MEMORY mode. Move cursor to the mode
desired. (Most recommended is 16 picture, 4-frame). Press SET
button to select.
5. When finished, press TALK button, or programming will
terminate in approx. 2-1/2 minutes. All the buttons are no
longer lit to indicate unit is in standby mode.
Notes:
When changing PICTURE MEMORY mode, all the previously
saved pictures will be erased. Never change if the saved pictures
MUST be kept.
It is not possible to go back and partially reprogram DATE
location or TIME. Go back to initial SET mode.
If setting has ended incompletely within approx. 2-1/2 minutes,
go back to initial SET mode.
[2][1]
[4]
[3]
DOOR
1
2
JA-DAC 2
JA-DAC 1
[1] [2]
[3] [4]
MONITOR
MONITOR
MONITOR
[1] [2]