Filter
Top Products
Aiphone KB Series 13710 (28 13 00) - 4
a. Lift handset and press ALL CALL button. ALL CALL button flashes red.
b. Call by voice and communicate when called person picks up to reply. ALL CALL
button turns on.
3. Answering Selective Call:
a. Double pre-tone sounds and caller’s voice is heard. ALL CALL button is steadily lit.
b. Without lifting handset, reply toward station microphone.
c. When conversation is complete, calling station hangs up handset.
4. Answering All Call:
a. Single pre-tone sounds and caller’s voice is heard. ALL CALL button flashes.
b. Pick up handset on any station, as needed. ALL CALL button is steadily lit.
5. Receiving Door Station Call During Internal Communication:
a. Chime tone is heard through handset being used and image comes on.
b. Hang up both handsets to end internal communication.
c. Answering station picks up again to answer door station.
E. Transferring Door Station Call:
1. Transferring:
a. While communicating with door station, press selector button or ALL CALL button.
Call-in LED begins flashing.
b. Call by voice and hear response from other door station. Inside audio cannot be
heard at door station.
c. First person hangs up handset after transferring call to second person.
d. Transferred station presses MONITOR button to connect to door station. Door
station call-in LED is steadily lit.
2. Receiving Transferred Call:
a. Sounds double pre-tone for selective call or single pre-tone for all call sounds and
voice comes in.
b. Lift handset and okay to answer door station.
c. Holding handset, press MONITOR button to connect with door station.
3. Activating Door Strike:
a. When door station calls, pick up any handset to reply.
b. While channel is established, depress and hold down DOOR RELEASE button.
1.5 SUBMITTALS
A. Comply with Section 01330 (01 33 00) – Submittal Procedures.
B. Product Data: Submit manufacturer’s product data, including installation instructions.
C. Shop Drawings: Submit the following:
1. Wiring Diagrams: Indicate wiring for each item of equipment and interconnections
between items of equipment.
2. Include manufacturer’s names, model numbers, ratings, power requirements, equipment
layout, device arrangement, complete wiring point-to-point diagrams, and conduit layouts.
D. Installation and Operation Manuals:
1. Submit manufacturer’s installation and operation manual, including operation instructions
and component wiring diagrams.
2. Provide detailed information required for Owner to properly operate equipment.
E. Warranty: Submit manufacturer’s standard warranty.