Filter
Top Products
27
System Dependent Phone Setting
Message Waiting Memory (MWM)
There is a message waiting memory in the telephone where the number to
the voicemail box shall be stored.
Save MWM
1. Place the handset on the phone and press
2. Press
and enter the number to be saved
3. Press
key again to complete saving
Dial from a MWM
1. Pick up the handset or press ‘Speaker/Handset’
2. Press the
Message Waiting LED
When there is a message, the message waiting LED will be lighted ON or
flashing in blue.
The Message Waiting switch (at the back of the phone) is used to select
the appropriate MW mode (HV / + / -). Please check which MW type the
PBX system supports. Select “OFF” on the MW switch to deactivate the
message waiting function.
If the LED is steady active, change the message waiting switch position.
Set Flash time
Some systems require a different flash time for the flash key. To change
the flash time, proceed as follows:
1. Press
# 0 1 # X #
where X is the flash time value between 1 and 9. See table below
Parameters Programming key sequence Lock
Protected
Valid
Settings
Default
Set flash
time
[save]+[#]+[0]+ [1]+[#]+[X]+[#] Yes 1: 100ms
2: 200ms
3: 300ms
4: 400ms
6: 600ms
9: 900ms
100ms