Filter
Top Products
Headset and Belt Pack Operating Procedures Model C5000
4 3M 1998 July
The Model C960AA Headset and Model C860AA Belt Pack Intercom controls
are shown below.
See the 3M™ Headset Intercom System, Model C960, Operating Instructions
and the 3M™ Belt Pack Intercom System, Model C860, Operating Instructions
for detailed information about headset and belt pack operations.
Figure 4. Headset and Belt Pack Controls
Press the ON switch to turn on the headset or belt pack.
Press the OFF switch to turn off the headset or belt pack.
Press to increase the volume. There are 15 available volume levels.
Press to turn the volume down.
Press either switch to connect to the calling location. Hold the switch to talk to
the customer. Release the switch to listen.
!
!!
! Note
If your location has more than one wireless system, contact your local dealer for
information about Talk switch (T1 and T2) operations.
Momentarily press and release to activate the Call Station scan feature.
(Also used to disconnect a Call Station and return the system to standby mode.)
Press and hold to talk to internal personnel without being heard by the
customer. Release the switch to listen. (With the switch released, you can hear
both customers and internal paging.)
Not used for this application.
Push the battery release up and hold it while sliding the battery out of the
housing.
!
!!
! Note
The C860 Belt Pack operates with either 1 or 2 batteries. If 2 batteries are used,
replace both at the same time.
Headset and
Belt Pack
1ON Switch
2 OFF Switch
3 Volume Up ▲
▲▲
▲
Control
4 Volume Down ▼
▼▼
▼
Control
5 Talk Switches
(T1 or T2)
6 Page/Call Station
Scan Switch
7 TALK/Lock Switch
8 Battery Release