Filter
Top Products
Station Selector Controls and Indicators Model C5000
2 3M 1998 July
The Station Selector controls are shown below.
Figure 3. Station Selector, Controls, and Indicators
ON turns on the Station Selector; OFF turns it off.
!
!!
! Note
The remotely located communications controller and the Station Selector are
designed to be left on. Notify your system administrator or manager if the
Station Selector power switch is off and turning it on does not illuminate the
power indicator light.
Turn to increase; or decrease the volume in the Station Selector speaker.
Lights to indicate the Station Selector power is on.
Press to initiate or answer a call to a specific Call Station.
(Station Selectors come in either 16-station or 8-station units.)
Lights in amber to indicate call status:
Flashing Light = A call is waiting to be answered.
Light Steady On = Call has been answered and connection is established to
the customer
Press to connect to the calling location. Hold to talk to the customer. Release
to listen.
Lights (red) when TALK key is pressed and held to indicate the system is in
talk mode. Extinguishes when the TALK key is released.
Lights (green) when TALK key is released to indicate the system is in listen
mode.
Press to end a call and return the system to the standby mode.
Lights to indicate the system is in standby mode.
Press to broadcast a call to all Call Stations at the same time.
Station Selector
1 POWER Switch
2 VOLUME Control
3 POWER Indicator
4 Station Selector
Ke
y
s
5 Call Indicators
1 through 16
(amber)
6 TALK Key
7 TALK Indicator
8 LISTEN Indicator
9 STANDBY Key
10 STANDBY
Indicator
11 ALL CALL Key