Filter
Top Products
Technician Troubleshooting Guide Model 478 (D-15)
Problem Possible Cause Correction
No outbound audio:
• Power Indicator Light
(green) is ON.
• TALK Indicator Light
(red) is ON when TALK
SWITCH is pressed.
Defective menu speaker,
menu mic, or wiring.
Check and replace menu
speaker, menu mic, or wiring.
Defective analog board. Check and replace analog
board.
With car on loop, VEHICLE
Indicator Light (yellow) is
ON, but vehicle detection tone
does not sound.
Alert volume control setting
too low.
Check and/or increase the
Alert volume control setting
on bottom of unit.
Defective analog board. Check and replace analog
board.
With car on loop, VEHICLE
Indicator Light (yellow) is
OFF, and vehicle detection
tone does not sound.
Defective logic or analog
board.
Check and replace logic or
analog board.
Outbound audio distorted. Defective analog board. Check and replace analog
board.
Defective internal
microphone.
Replace microphone.
Defective menu sign
speaker.
Replace menu sign speaker.
3M Media InTouch
3M Center, Building 551-1E-02
St. Paul, MN 55144-1000
Printed on 50% recycled paper,
including 10% post-consumer waste.
Printed in U.S.A.
© 3M 1997 January
78-6912-0660-7 Rev. A