![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/9/79/9796c7f8-7005-48ca-b5ea-877ddd01f1d7/9796c7f8-7005-48ca-b5ea-877ddd01f1d7-bgd.png)
15. Identify the two V-pulleys (46), the nine Thick
Pulleys (not shown), and the two Thin Pulleys
(not shown).
Route the Arm Cable (54) over a V-pulley (46).
Attach the V-pulley (46), a Large Cable Trap
(50), two Full Guards (41), and an M10 Washer
(57) to the Upright (3) with an M10 x 63mm Bolt
(75) and an M10 Locknut (56).
Make sure that the Large Cable Trap (50) is
oriented to hold the Arm Cable (54) in the
groove of the V-pulley (46).
15
i7 46
50
41
75
16. Route the Arm Cable (54) around a Thick Pulley
(48).
Attach the Thick Pulley (48) and two Half
Guards (43) to the Double U-bracket (63) with
an M10 x 46mm Bolt (81) and an M10 Locknut
(56). Make sure that the Half Guards are on
the outside of the Double U-bracket as
shown.
16
54
48
56
17. Route the Arm Cable (54) over a V-pulley (46).
Attach the V-pulley (46), a Large Cable Trap
(50), two Full Guards (41), and an M10 Washer
(57) to the Upright (3) with an M10 x 63mm Bolt
(75) and an M10 Locknut (56).
Make sure that the Large Cable Trap (50) is
oriented to hold the Arm Cable (54) in the
groove of the V-pulley (46).
17
75/%
46
13