DIGITAL RF
ANTENNA
DIGITAL ANTENNA INPUT
Analog RF Antenna Connection
• Connect a Cable signal (with or without a cable box),
Satellite Receiver, or RF antenna to the “UHF/VHF/
CATV” terminal.
The analog tuner in this LCD Projection TV receives
Analog Antenna signals, Analog Cable signals, or the
RF output from a Satellite Receiver, VCR or cable box.
VCR BACK
OR OR
Notes:
If you do not have a VCR, connect signal directly to the 75 ohm
terminal (UHF/VHF/CATV).
Don’t be fooled by the phrase “Available in High-Definition.”
The only resolution available with any of these connections,
regardless of the original content, is standard analog (SDTV).
CATV FRANCHISE NOTE: Cable companies, like public
utilities, are franchised by local government authorities.
To receive cable programs, even with equipment which
is capable of receiving cable channels, the consumer
must subscribe to the cable company’s service.
■ The LCD Projection TV will select the correct Antenna mode
for the type of Analog RF signal connected automatically.
■ Use “Analog Antenna Signal” in the Setup menu (see page
22) to change the Antenna Mode.
■ If you move the LCD Projection TV to a new location, press
the RESET key twice after connecting the signal and turning
on the LCD Projection TV. See RESET key description on
page 19.
PTV BACK
ANALOG RF
ANTENNA
PTV BACK
PTV BACK PTV BACK
1
Digital (DTV) RF Antenna Connection
• Connect an RF antenna to the “Digital Antenna In”
terminal.
The digital tuner in this LCD Projection TV receives HD
signals from an antenna. Digital signals from a set-top
box (STB) are received through the Component In jacks.
This LCD Projection TV can receive ANY resolution
being broadcast (HDTV, EDTV, or SDTV).
INITIAL SIGNAL CONNECTIONS
GETTING STARTED (Required Initial Setup)
(Continued on next page.)
ANALOG SATELLITE RECEIVER