Maintenance
Water supply hose filter / Ag Air-filter / Lint filter / Main unit and tub
1. Turn off the water faucet.
2. Press the [Power On] button.
3. Press the [Start/Pause] button.
The Water Level will light up a few seconds later.
4.
Press the [Power Off] button to turn off the power.
5. Loosen the nut.
6. Take off the hose.
7. Clean the filter.
Water supply hose filter
• When water supply seems constricted.
• Be absolutely sure to follow
the procedures as described,
otherwise water will spray out.
Lint filter
• Remove the accumulated lint regularly. When the filter is full of lint, the filter could
be torn from rubbing with the laundry during washing cycles.
1
(Lint filter A)
Remove the lint
filter A.
2
3
(Lint filter A)
Put the filter back in.
Make sure it clicks
into place.
1
(Lint filter B)
Pull out the lint filter B
from the lock.
By using fingers to
press and pull out at
the upper part of the lint filter’s side.
Remove the lint
from the filter.
3
(Lint filter B)
Set it back to the
original position.
• Insert the bottom
first as shown in the figure.
•
Press down and lock as the arrow.
• When the filter is torn, etc., obtain another one from the place of purchase.
• Turn the wash tub if the filter cannot be removed easily.
• Upper part of the tub
Wipe with a damp cloth.
✻ Do not apply water directly.
The floor could get wet.
Main unit and tub
• Main unit
Wipe with a soft cloth. Use a neutral dishwashing liquid or soap
for stubborn places.
✻ Do not apply water directly.
✻ Do not use cleanser, paint benzine, alcohol, kerosene, etc.
✻ Follow any instructions that come with a chemically treated cloth.
Ag Air-Filter
✻ Do not wash
with water.
1 Remove the filter cover, then
pull out the Ag Air-Filter.
2 Remove any kind of dust
from the filter.
3 Set it back to the original position
by pressing the left /right sides of
the filter cover.
✻ Do not press the middle of the
filter cover.
Maintenance
To prevent from fungus growth at the outer tub area.
“Tub Dry”
Remark: Please be informed do not put laundry inside the tub during this Program.
1
Press the [Power On] button.
2
Press the [Program] button 6 times
for [Tub Hygiene] Course.
• The [Tub Hygiene] light will be indicated.
3
Press the [Wash] button and the [Rinse] button once each to select only [Spin].
4
Press the [Start/Pause] button.
• Spinning operation will be operated for 30 minutes
The buzzer lets you know when the washing is finished.
1
2
4
3
NA-F90H2_EN_AR-PE-V2.indd 18 11/23/11 3:41:38 PM
