- 42 -
➢ When the bristles on the agitator are
worn so that they do not touch a
card held across the lower plate, the
brushes should be replaced.
➢ Remove lower plate and agitator.
➢ Remove the E-clip from agitator
shaft and end cap.
➢ Do not bend agitator shaft or lose E-
clip or spacer.
➢ Pull agitator shaft out of agitator
body.
➢ Pull, or pry out, agitator holder and
agitator pulley.
➢ Push each brush out of agitator
body as shown.
➢ Install new brushes by reversing
procedure.
➢ Reinstall agitator holder and agitator
pulley completely.
➢ Reinstall the agitator shaft, end cap
and E-clip.
➢ See exploded view for correct
assembly of parts.
➢ Position belt over agitator pulley on
the agitator.
➢ Reinstall agitator and lower plate.
