22
Finding the controls
Main unit
5
1
2 3 4
6
14
12
15 16 19181713
8
9
10
11
7
Liquid crystal display
The display turns off after about 2 minutes
of inactivity.
To turn on the display, press (Stop).
Call/Fax List button starts a search in
— the Number Display (Caller ID) log.
— the fax list stored in memory.
Call/Fax List indicator lights when
— a call was missed.(For Number Display
service users.)
— a fax was stored in memory.
Speed Dialer button
Function button initiates programming.
Volume/Change/Redial/Phonebook key
To adjust the volume (see below).
To change Hiragana into Kanji.
To adjust the ringer volume when the unit
is on stand by
(Select
“
”
)
(Set)
(press repeatedly)
To adjust the receiver volume while
talking, press
repeatedly.
To adjust the speaker volume while
listening to the recorded messages or
using the monitor, press
repeatedly.
To redial the phone numbers in
the redial list. The last 10 phone
numbers dialed are stored in
memory.
To use the phonebook.
Auto Answer button & indicator
—light on: answering device activated.
—light off: used as a regular telephone.
Playback button plays back recorded
messages.
Flash button (For call waiting service users.)
Fax button starts faxing.
Copy button starts copying.
Power indicator
SD Memory Card cover
SD indicator
Multi-operation buttons refer to the function
displayed on the display panel.
Hold button
Intercom button
Monitor button
Tone button switches to tone dialing.
Night mode button
Sharp button
Key lock button can lock the main unit so
that no calls or settings can be made. To
turn key lock on, press this button for about
3 seconds until a single beep is heard.
“ ” is displayed.
To turn key lock off, press this button for
about 3 seconds.
Stop button
KX-PW608DL_DW_QG.indb 2 2008/12/18 13:22:58
