– 17 –
Controls and their functions
Connector section
Remote control section
(26) REMOTE IN RS-422A serial mode input connector.
connector
(RS-422A) (9P)
(27) REMOTE OUT RS-422A serial mode output connector.
connector
(RS-422A) (9P)
(28) REMOTE IN/OUT RS-422A serial mode I/O connector.
connector (9P)
(29) V/A CONTROL Encoder remote (AJ-ER50) connector. (see Note)
terminal (15P)
(30) RS-232C Data communication is possible by connection to a personal computer or a
connector (25P) modem.
(31) CONTROL PANEL For connection of the cable of a control panel.
connector (20P) The control panel connector enables the connectors on the front panel and
connectors on the rear panel to be connected, and when these connectors are
simultaneously connected, it is possible to switch between them using the menu.
(32) PARALLEL 50-pin parallel remote connector.
(IN/OUT) terminal (Mainly for connection of equipment produced by the user.)
(50P)
ONoteN
The AJ-ER50 “Video input” and “VIDEO-PHASE” functions are not operational, as there is no correspondence with this
recorder. Also, SYS-PHASE should be set at this recorder and not at the AJ-ER50.
