5
Drill the 1/32 inch diameter starter holes for the AR Mounting Screws 3.
and the 1/2 inch diameter hole to route the AR Interconnect Cable
through the deck. Make sure the gasket is sealed tightly against the
deck
Insert AR Interconnect Cable through the deck and pull it through 4.
Using the four AR Mounting Screws provided, mount the AR to the 5.
deck
Insert AR Screw Caps into AR Bolt recesses on the AR Cover.6.
3. AR Flush Mount Installation (above deck)
In this AR Flush Mount
installation, the cable is routed out
the back of the LWX-1.
This installation is the same
as AR Flush Mount through-
deck Installation, except the AR
Interconnect Cable is routed
under the LWX-1 and out the back
above the deck instead of through
the deck.
To use AR Flush Mount above-deck installation:
With a pair of needle-nose pliers, break away and remove the AR 1.
Channel Stop
Insert the AR Interconnect Cable into cable channel on bottom of 2.
LWX-1
Ensure that the rubber boot on the AR Interconnect Cable is rmly 3.
in the AR Rubber Boot Inset so that it is ush with the bottom of the
AR Base.
