31
Step 3
Install
standoffs
onto handles
• Place a handle standoff onto each attachment post
along the handle. Position the set screw hole on the
standoff to point to the floor.
• Install set screws into the bottom of each standoff,
using the Allen wrench provided. The standoff should
be tight against the handle.
Step 4
Install
handles
and panels
FOR CUSTOM
WOOD
PANELS
See Step 4A
for stainless
steel panels
• Slide panel into the door trim. Leave about 4" of the
panel exposed to allow room to install the handle
extrusion.
• Place extrusion onto the back side of the panel, install
mounting screws through the extrusion and just
through the panel.
• Drive screw part way through the top standoff, then
part way through the bottom standoff. Install remaining
standoffs part way.
• Drive all screws until the handle is tight against the
panel.
• Remove tape.
• Slide the assembled panel into the door trim until the
extrusion fits firmly against the steel door. Reinstall
original screws into the extrusion.
